1. Before starting the automatic cable tie machine, carefully check whether there is any debris on the workbench of the winding machine, whether the screws on the half cable tie machine are loose, whether the power switch is properly connected, and whether the specifications of the enameled wire meet the requirements. It can be turned on only after being qualified. If any fault is found, it should be reported to the foreman or biotechnologist for repair in time.
2. Run the car with an empty car after starting up. Pay attention to check whether the cable tying machine, the number of winding turns, the reset method, the parking position, etc. meet the requirements. If it does not meet the requirements, you must repeat the above steps and re-adjust until Until the requirements are met.
3. When you find loose screws and abnormal sounds during operation, please press the emergency stop switch immediately and report to the foreman or biotechnologist for repair.
4. It is strictly forbidden to touch the moving parts when the cable tie machine is running at high speed. Use the machine in strict accordance with the operating specifications of the cable tie machine. It is forbidden to start the machine when hanging the wire or loading and unloading the skeleton fixture.
5. Before leaving get off work, the operator should carefully clean and maintain the equipment according to the requirements, and do a good job in the cleaning and sanitation of the surrounding area. The product parts should be placed neatly and the power supply should be turned off.
